Can I add a resin to seal small holes in the hull of an aluminium boat? - aluminium boat flooring installation
The hull is about 20 years ago and began to flee. He built a tank and tell me they can not be a soldier. The hole / holes in the tank, which can be removed without great difficulty, is located.
Jelp please.
Tuesday, December 1, 2009
Aluminium Boat Flooring Installation Can I Add A Resin To Seal Small Holes In The Hull Of An Aluminium Boat?
Subscribe to:
Post Comments (Atom)
1 comments:
You probably have a severe corrosion problem, and these holes are the first signs of an incipient fault.
You can use the temporary repairs that might be true in the short term use, but are a major problem in the future.
I might still allowed to stay in my boat, the internal fuel tanks. Too many questions remain, until a catastrophic failure hidden - sometimes I have to save these boats. Caches are only hidden (sometimes fatal) problems, rotting wait in silence, to stop the annoying, can be explosive, and always be expensive. They are a marketing tool, and give a feeling of less clutter and make the fuel load in the boat. Undoubtedly, the red, which they describe as the region is not broadcast - is perhaps the manufacturer, a layer of rubber or similar material under the tank to prevent strikes - this will still allow corrosion Foster - also question first.
You have two options. 1) Bite the Bullet, and properly adjusted. 2) Bog go of him and pretend
Post a Comment